An ISP programmer for AVR microcontrollers.
FEATURES
- Faster than one which uses a legacy serial port.
- Simple circuit.
- Built-in FTDI's official driver.
- Built-in simple filer.
- Logging UART from MCU via MOSI pin.
LOGGING UART
- Logging via MOSI, not MISO. Non-inverting UART.
- New line is CR or LF or CR+LF.
- Only ASCII.
- In this mode, ADBUS0(TXD, SCK) and ADBUS2(RTS#, MISO) output H.
- SCK/MISO are not able to use as GPIO. Please set their DDR to input.
USB-OTG
- Please check that your phone supports USB-OTG.
- The phone catalogue which Google Play has may be wrong.
NOTES
- To make an adapter is required. Its schematic is in this app.
- The cost of parts is about US$20.
- The PDI/TPI are not supported, which are next generation interface.
- Only Intel HEX is supported.
- If your phone can not resume USB, you had better to disable sleep.
Un programmatore ISP per microcontrollori AVR.
Caratteristiche
- Più veloce di quella che utilizza una porta seriale legacy.
- Circuito semplice.
- Built-in pilota ufficiale di FTDI.
- Built-in semplice filer.
- Logging UART da MCU tramite pin MOSI.
REGISTRAZIONE UART
- Registrazione via MOSI, non miso. UART non invertente.
- Nuova linea è CR o LF o CR + LF.
- Solo ASCII.
- In questa modalità, ADBUS0 (TXD, SCK) e ADBUS2 (RTS #, miso) H. uscita
- SCK / MISO non sono in grado di utilizzare come GPIO. Si prega di impostare il loro DDR all'ingresso.
USB-OTG
- Verificare che il telefono supporta USB-OTG.
- Il catalogo telefono cellulare che Google Play ha può essere sbagliato.
NOTE
- Per fare è richiesto un adattatore. Il suo schema è in questa applicazione.
- Il costo delle parti è di circa US $ 20.
- Il PDI / TPI non sono supportati, che sono l'interfaccia di nuova generazione.
- Solo Intel HEX è supportato.
- Se il telefono non può riprendere USB, è meglio disabilitare il sonno.